This board is powered by Makita 18v lithium ion batteries or off-brand replacements. The board can be rotated and twisted 360 degrees. Comes with 6 L.E.D. strips, 1 warm center offset, 2 warm outer, 1 cool center offset and 2 cool outer. 3 switches on base control strips. 2 Outer switches have single on and Center has a double on. Right Outer switch turns on 2 outer cool white. Left outer switch turns on 2 outer warm white. Center up turns on 1 center offset warm and center down turns on 1 center offset cool. Batteries charge in 15-40 min and last for 4 to 10 +hours depending on how many strips you power and what size battery your using.
*Custom cool/warm white configurations available upon request
New Spinal-Cord Setup
Elim A Dents Patent Pending Spinal Cord setup. These new revolutionary fittings allow you to extend and shorten your cord length without taking the entire assemble apart. Better than that each link has a bolt and nut inside a plastic housing that allows you to set the tension of each link. Ounce Spinal Cord fittings are connected they cannot pop apart without loosening the tension screws. If you prefer that loose broke in feel loosen the screws, if you like to keep that tight like new feeling tighten the screws. If you would like to have part of the links loose so you can maneuver and spin the board freely but have another section tight to support the board’s weight well you can do that also.
> 18v powered by Makita lithium ion batteries or off-brand replacements.
> Allows you to use existing Makita chargers and batteries to eliminate carrying multiple different batteries and chargers.
> Easy battery release for swapping out dead batteries
> Completely cordless no exposed wires.
> Versatile 360 degrees of movement with no worries of cord tangles.
> Quick disconnects to easily replace wearable parts like the loc line assembly.
> Up to 9 18v strips with a variety of warm/cool color combination.
> 3 independent switches on base so they don't get switched by accident when adjusting board and also allow for various led strip combinations.
>Matched acrylic face plate for the perfect fade. Acrylic is secured into place so it won’t slide or fall out.
>Built in suction cup with replaceable plunger and pad which saves cost on repairs by only needing to purchase parts instead of entire assembly. Now works with Woods and Ram Twist Cups
>Low profile dimmer on base side to control brightness of L.E.D.
|Subtotal|| $0.00 USD|